Use saved test results
Save test results so Poolometer can use your FC and CYA here.
Winterization safety
Treat closing and winter blowout as a system isolation task. Safe inspection comes first; pressurized air, heater drainage, and specialty valves do not.
- ✓ Remove accessories, document water level, and follow the exact manual for the pool type and climate.
- ✓ Confirm plugs, returns, skimmers, and valve positions before you assume the line is isolated.
- ✓ Write down what was drained, plugged, or bypassed so spring restart starts from facts.
- ★ Blow out lines, winterize heaters, or isolate in-floor or specialty plumbing when the zone layout is not fully understood.
- ★ Drain and preserve equipment that depends on model-specific service steps.
- ★ Handle compressed-air winterization when the correct valve path is not obvious.
- ⚠ You cannot verify which line is isolated, or the system still contains pressure you cannot explain.
- ⚠ A heater, pump, or controller behavior makes the winterization path unclear.
- ⚠ Any freeze-risk situation that would get worse if you guess at the next step.
Close the pool so spring is easier
Balance, clean, protect, and document before the cover goes on
- Balance, clean, protect, and document before the cover goes on
- FC
- pH
- CYA
- TA
- CH
- Never use automotive ethylene-glycol antifreeze in pool plumbing.
A good closing is not about throwing in chemicals and walking away. It is about leaving a stable, documented, low-risk system.
- ✕Do not hide a green or contaminated pool under the cover
- ✕Do not use automotive ethylene-glycol antifreeze in pool plumbing
FC / pH / CYA / TA / CH
Clean and balance before closing
Organic debris left in the pool is future chlorine demand and future stain risk.
Drain and protect equipment as the manual requires
Use ranges that protect the surface and equipment instead of magic numbers.
- For plaster and aggregate pools, pay extra attention to CH and saturation index before closing.
Inspect cover and anchors
The goal is to close with clean, adequately chlorinated water.
Store plugs, baskets, and notes together
This is the mechanical heart of the closing process.
- Never use automotive ethylene-glycol antifreeze in pool plumbing.
Set water level for the cover system
Water level depends on the cover strategy and the winterizing procedure.
Treat the cover as a safety system
The closing is not finished until the site is secure.
Resources (1)
Weekly / Monthly / Quarterly Maintenance Routine Packet
A printable owner packet that turns weekly, monthly, and quarterly pool maintenance into one repeatable checklist.
Educational guidance only. Verify labels, manuals, local code, and site conditions before acting. Stop for electrical, gas, structural, drain, drowning, injury, emergency, or chemical-mixing risk.